148
iii-1
iii-2
iii-3
iii-4
1
2
3
4
5
7
6
8
Installation
iii Installation procedure
Unit:
Refer to the drawing in i section for correct wheel bal-
ancer positioning. If the wheel balancer needs secur-
ing, we recommend fi xing elements with a diameter of
8 mm, quality 8.8 or higher.
Supports for Accessories:
•
Refer to
Figure iii-1
.
•
Unpack the 4 threaded accessory support pins and
the support plates.
•
Fit the 4 threaded accessory support studs and the
plates.
Threaded shaft
(if present)
:
•
Refer to
Figure iii-2
.
•
Clean the threaded shaft and the hole in the main
shaft.
•
Position the threaded shaft.
•
Use a pin for screwing.
Wheel guard:
Note:
The wheel guard infl uences the following
modes of operation:
-
The measuring run is started by closing the
wheel guard.
-
The wheel is braked on lifting the wheel guard
during a measuring run.
•
Refer to
Figure iii-3
.
—
Slide the wheel guard (
1
) on the support shaft (
2
)
and raise it until the wheel guard fastening holes
match with the support shaft holes.
—
Insert the M10 fastening screw (
3
) with washer (
4
)
from below, and tighten the hexagon nut (
5
) and
washer fully home.
•
Refer to
Figure
iii-4
—
Connect the plug of the cable (
6
) with the connector
of the
machine (
7
) which is projecting out of the
opening in the machine cabinet.
—
Place the cable and the connector inside the cabinet
(
8
).
Caution
:
Since the cable is moved when opening and
closing the wheel guard, it must be fi xed in position
with straps but it must be suffi ciently free in the
protection joint area.
Clamping devices:
•
Put the clamping devices on the accessory support
pins and in the appropriate housings.
Содержание Sun SWB 340
Страница 142: ...142 Blank Page...
