Scanner
Basic Operation
11
4.1.2 Scanner Demonstration Mode
The Scanner demonstration mode allows you to interact with and explore Scanner
functions without connecting to a motorcycle.
z
To use the Scanner Demonstration Mode:
1.
Select
Scanner
from the Home screen.
2.
Select
Demonstration
from the vehicle Make menu.
IMPORTANT
Do not connect the diagnostic tool to a motorcycle while in
Demonstration Mode.
3.
The simulated vehicle identification process starts. Follow the prompts to enter
the motorcycle identification information and then select
OK
to confirm. The
demo motorcycle is a 2017-H, CVO Limited (FLHTKSE)-TE 114 cu in. (Twin
Cooled Milwaukee Eight)-F.
4.
A warning message displays “Demo mode: Do not connect to vehicle.”. Select
Continue
.
5.
Select a
System
(e.g. Engine, ABS, Body Control Module). The Systems
menu shows all of the systems supported by the motorcycle for testing.
6.
Select a
Function/Test
. Depending on which system is selected, different
choices are available. Examples: Codes Menu - view trouble codes, Codes
Scan - scan all systems for trouble codes, Data Display - view engine
parameters (PIDs), Functional Tests - perform bi-directional tests on
components.
4.1.3 Scanner - Starting / Stopping
z
To start the Scanner function:
1.
From the Home screen, select the
Scanner
icon.
The vehicle identification process starts. The motorcycle must be correctly
identified for the diagnostic tool to communicate, and display data correctly.
2.
Follow the onsceen instructions to identify the motorcycle and connect the
data cable. See
Vehicle Identification / System Selection
NOTE
Damage to electronic control modules may occur if communication is
disrupted. Make sure the data cable is properly connected at all times during
testing. Exit all tests before disconnecting the data cable or powering down the
diagnostic tool.
The Scanner function remains open as long as there is an active communication link
with the motorcycle. You must interrupt this communication link in order to exit from
tests and power down the diagnostic tool. A warning message displays if you attempt
to shut down while the diagnostic tool is communicating with the motorcycle.
z
To exit the Scanner function:
1.
From any active Scanner screen, select the
Back
icon on the toolbar.
The “stopping communications” message briefly displays followed by the Data
menu.
2.
From the Data Menu, select
Back
on the toolbar.
The “stopping communications” message displays again, then the Main menu.
Once the Main menu is displayed, communication has been terminated and it
is safe to return to the Home screen and power down the diagnostic tool.