To select Contact Sequential Actuation Mode (see Figure 2):
1. Press and hold Actuation Selector embedded in the
trigger.
2. Rotate Actuation Selector up to the Contact
Sequential Actuation (TTT).
3. Release Actuation Selector, ensuring locking tab is
fully seated in the slot.
Ensure selector has locked into position. Ensure
actuation process is fully understood before attempting to use clipped head
nailer.
TO USE THE CLIPPED HEAD NAILER IN CONTACT ACTUATION MODE:
1. Firmly grip clipped head nailer handle.
2. Pull and hold the clipped head nailer trigger.
3. Push clipped head nailer against work piece compressing work piece contact.
4. The clipped head nailer will drive nail upon contact. The clipped head nailer will
recoil away from the work piece as nail is driven.
ADJUSTING DEPTH OF NAILING
Be aware of material thickness when using nailer. A pro-
truding nail may cause injury.
Adjust the depth of nailing by loosening the two hex
nuts (figure 3). Move nosepiece down for a shallow-
er nail depth or up for a deeper nail depth. Once
nosepiece is adjusted, tighten hex screws. To
increase the depth of the nails when the nosepiece
is already set to its lowest setting, increase the air
pressure. To decrease the depth of nails when the
nosepiece is already set to its highest setting,
decrease the air pressure.
Always disconnect the clipped head nailer before mak-
ing any adjustments to the nail depth setting.
USING THE HOOK
Always disconnect the air hose before hanging the clipped head nailer with
the hook.
NEVER hook the clipped head nailer in a high location or on an unstable platform.
LOADING NAILS INTO THE AIR NAILER
Always disconnect the air hose from the clipped head nailer before adding
or removing nails.
NEVER use deformed nails or nail strip. Failure to observe this precaution
can result in poor nail feeding and/or jams in the feeding mechanism.
To load nails in clipped head nailer, slide nails through magazine inlet in back of mag-
azine. Pull pusher back until it is behind nail strip, then release pusher.
To remove nails from clipped head nailer, pull slightly back on pusher and depress
spring lever (Figure 4). Allow pusher to pass over nail strip and move strip to back
of magazine. Depress the nail stop allowing nail strip to be removed from magazine
inlet.
11
12
Figure 3
Figure 4
Figure 2