Snap-on Equipment EELR501A, Инструкция по установке и эксплуатации

Страница: 47 / 75

47 of 73
12.13
Lubrication of Pivot Point and Sliders
In some instances, a clicking noise can be heard from the pivot points and rear slides of the scissor
lift. This noise is a result of low contact pressure on the bearing surface that creates a stick-slip
situation. In order to reduce or even eliminate this noise immediately, it is recommended to use a
motorcycle chain lube like a
Kleenflo Honey Goo CHAIN LUBE
at all slider and pivot point locations.
This product can be used for ongoing maintenance on a monthly or as needed basis.
Instructions:
• Raise the lift to its maximum working height without any weight or vehicle on the lift.
• Apply the lubrication using a straw attached to the nozzle.
• The lubrication can be applied to all pivot points and sliders.
• Review Figures 43 - 47 for more information on applying the lubrication to specific locations.
• After spraying the lubrication, operate the lift for a few cycles to move the lube into the
pressure face of the slider or bushing.
• Re-application may be necessary in some locations.
• If noise still persists after application, have someone operate the lift while you spray the
lubrication into the pivot or slider location.
Figure 43 – Lubrication points (opposite side of all locations should be lubricated as well)