Snap-on Equipment EELR501A, Инструкция по установке и эксплуатации

Страница: 44 / 75

44 of 73
12.3
Air Cylinders, Air Lines, Valve and Fittings
Check FRL (Filter/Regulator/Lubricator) in the right side of console.
Drain water trap filter bowl and adjust oil feed according to manufacturer’s instructions.
Drain water bowl on lift supplied water separator. Press valve at the bottom of the bowl to clear.
Check operation of air release valve for air leaks.
Check air cylinders for visible damage.
Check air lines for leaks, wear or kinks.
1. The Air Lubricator is located on the outside of the console which allows for easy monitoring of the
oil level.
2. If oil level is low:
a. Unscrew the filler cap from the Lubricator.
b. Refill using Snap-On Air Oil #IM6 or equivalent. The oil level should not be higher than
4/5 of the oil reservoir height.
c. Reinstall the filler cap.
Figure 41 – Check Oil Level of Air Lubricator
12.4
Hydraulic Power Pack and Hose
Check all air and hydraulic hoses, fittings and cylinders for leaks.
Check level of oil in power pack reservoir when lift is in the lowered position. Add if required.
Check fluid level of lift power unit and refill if needed. If refill was needed, inspect all fittings, hoses
and seals. Tighten, repair or replace as required.
Change hydraulic fluid every 2 years.
NOTE: Failure to maintain oil level in lubricator will void warranty
on all pneumatic components.