Snap-on Equipment EELR501A, Инструкция по установке и эксплуатации

Страница: 36 / 75

36 of 73
9.0 INSTALL FRONT TURNTABLES
9.1
Installation of Front Turntables
1. Position the lift at a comfortable working height and lower onto a mechanical safety lock.
2. Place each front turntable assembly on the front alignment pan of the runway. Moving lock
handles of the turntables should be oriented to the outside of lift, See Figure 34 (a) .
3. If the surface of turntable is not flat with the runway, the turntable support can be adjusted to
level with runway by using the 6 adjustment bolts under the support plate
.
See
Figure 34 (b)
.
Tighten the jam nuts on the adjusting screws after adjusting.
4. Verify that the turntable assembly is completely seated in the front alignment pan. Gently slide
each turntable in the alignment pan, left and right, to verify that they can be positioned for
different car widths.
a. Position Turntable b. Turntable Height Adjustment
Figure 34 – Turntable Position and Adjustment
9.2
Moving and Locking the Rear Slip Plate
- The Rear slip plates are pre-assembled on runway, seat on the 31 transfer balls and locked by
two 90º angle lock pins, see Figure 36;
- During alignment process as needed, pull out two lock pins and insert into pin storage;
- The slip plate can now move as required