WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Outback Wind Breaker
Part # 902xx
07-11 JK (2-Door)
Step 1:
Depending on what your vehicle is equipped with remove your hardtop or lower your soft top.
This part can be installed with the soft top lowered back, but if you plan to install this part in
conjunction with a Tonneau cover the soft top and bow assembly will need to be completely
removed. It is also recommended for safety reasons to remove the bow assembly pivot brackets
from the roll bar using a #30 torx bit.
Step 2:
Position the Windbreaker between your sport bar with the zippered flap on towards the back.
Fasten the windbreaker by running the strap around the sport bar and through the buckle. (Fig A)
Start with the top two center straps. (Fig B) Do not tighten completely at this time.
(Fig A)
(Fig B)
Step 3:
Now secure the two straps on each side and one on each top corner of the windbreaker. (Fig C, D)
Step 4:
Secure the bottom four straps (2 per side) loosely around the back of the vehicles front seat
risers. (Fig E,F)
Step 5:
Position the windbreaker so it’s in the optimal centered location and then proceed to tighten
all of the straps and buckles. Installation is now complete.
Note:
The zipper on the back of the windbreaker underneath the flap to attach the Smittybilt Tonneau
cover.
Note: Please read instruction entirely before installing this product.
Fasten the windbreaker by running the strap
around the sport bar and through the buckle. Start
with the top two center straps. Do not tighten
completely at this time.
Slide the strap up through the rear slot
in the buckle then down back through
the front slot in the buckle.
