Smith SPS10, Операция - Ремонт - Запчасти

Страница: 33 / 68

Troubleshooting
3A5578D 33
Troubleshooting
To avoid injury from unexpected start up, disconnect
spark plug wire before you service your unit.
Problem Cause Solution
Cutters wearing
unevenly/prematurely
Drum is too low Raise drum
Material build-up Clean the cutters
Cutters too tightly loaded Remove some spacers or cutters from shafts
Wrong cutters for application See 17X074 (Surface Profile Chart)
Cutters shaft breakage
unevenly/prematurely
Drum is too low Raise drum
End plates or bushings worn Replace the end plates and/or bushings
Shafts worn Replace the shafts
Wrong cutter set up
Visit
www.SMITH.com/drumassembly
for
proper setup
Over 40 hours service life Replace shafts and bushings
Drum wearing prematurely
or cracking
Drum hitting ground Raise drum
Shafts and bushings not replaced within 40
hours Replace shafts and bushings
Excessive vibration
Bearing worn Replace worn bearing
Hex bushing worn Replace hex bushing
Drive shaft worn Replace drive shaft
Improper cutter setup
Visit
www.SMITH.com/drumassembly
for
proper setup
Drum contacting ground Raise drum
Wheels worn out Replace wheels
Machine jumps erratically
Drum hitting ground Raise drum
RPM is too low Increase engine RPM
Surface is severely uneven Move to smoother surface
Drive belt wearing prema-
turely
Pulley is misaligned Align pulleys/belt. See page 29.
Wrong belt Replace with correct belt
Drum is contacting the surface Raise drum
Drum Engagement Lever will
not raise/lower (non-DCS
models only) Drum Adjustment Dial is set too high or low. Raise or lower Drum Adjustment Dial
Drum Adjustment Dial will
not turn
Threads are dirty or not greased. Clean and grease the threads
Linkage may be bent Replace linkage
Uneven cutting
Cutting too deeply Raise drum
Rear wheel fork is bent Replace rear wheel fork