Smitec Cosmos 315 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 61 / 106

COSMOS DRIVER SERIES 3000 - USE AND MAINTENANCE MANUAL
1.1.19
INP-DIG - Digital input status.
1.1.20
OUT-DIG - Digital output status.
1.1.21
INP-A1 [V] - Analogue voltage 0-10V applied to input 1.
1.1.22
INP-A1-MIN [V] - Minimum value of the analogue input 1.
1.1.23
INP-A1-MAX [V] - Maximum value of the analogue input 1.
1.1.24
INP-A2 [V] - Analogue voltage 0-10V applied to input 2.
1.1.25
INP-A2-MIN [V] - Minimum value of the analogue input 2.
1.1.26
INP-A2-MAX [V] - Maximum value of the analogue input 2.
1.1.27
OUT-A [V] - Value of the analogue output 0-10V.
1.1.28
OUT-A MAX [V] - Max value reached by the analogue output 0-10V.
1.1.29
BOARD TEMP
[°C] - Logic board temperature.
1.1.30
VDC MAIN [V] - Auxiliary voltage.
1.1.31
MEASURE RESET 1 Elimination of max and min values recorded
Options=No, Yes.
7.2.5 Status menu
7.2.5.1 Models for brushless motor
Menu Entry Lev . Description
1.2 >STATUS - This section includes detailed information about the
driver status.
1.2.1 DRIVE STATE - Driver status; see chapter 9.2 in order to decode any
errors
1.2.2 LAST ERRORS - List of the last 3 errors; chapter 9.2 in order to
decode any errors
1.2.3 ERROR LIST CLEAR 1 Elimination of the error list.
Options=No, Yes
1.2.4 HARDWARE STATE - It displays hardware diagnostic information
7.2.5.2 Sercos II Cosmos
Menu Entry Lev. Description
1.2 >STATUS - This section includes detailed information about the
driver status.
1.2.1 DRIVE STATE -
Driver status; see chapter 10.1 to decode the error.
1.2.2 LAST ERR - List of the last 8 errors; see chapter 10.1 to decode
the errors.
1.2.3 SERCOS STATE - Sercos interface status; see chapter 10.2 to decode
the errors.
1.2.4 LAST ERR - List of the last 8 errors in the Sercos; see chapter
10.2 to decode the errors.
1.2.5 HARDWARE STATE - It displays hardware diagnostic information.
1.2.6 RESET ERROR 1 It allows cancelling the list of the last errors.
Ver. 1.07 Pag. 61