5
Manufacturer
a
Instruction manual
0
7
1
1
/
9
0
0
0
6
8
8
1
3
9
*
6
8
8
1
3
9
*
Levelling
Intense noise, vibrations and “wandering” may be the result of incorrect levelling.
Levelling the washing machine with a spirit level
1.
Loosen the lock nut using a spanner, by turning it in a clockwise
direction.
2.
Change the height by turning the appliance feet.
Caution:
all four appliance feet must be firmly on the ground.
The washing machine must not wobble.
Check the levelness of the washing machine with a spirit level and adjust
if necessary.
3.
Tighten the lock nut against the housing.
In doing so, hold the foot tight and do not adjust its height.
Caution:
the lock nuts on all four appliance feet must be screwed tightly
against the housing.
Electrical connection
ʑ
The washing machine must only be connected to an alternating current via a
properly installed earthed socket.
ʑ
The power supply and voltage indicated on the washing machine (rating plate)
must be the same.
ʑ
The connected load and fuse required are specified on the rating plate.
ʑ
Make sure that:
– the mains plug fits the socket,
– the cable cross-section is adequate,
– the earthing system is properly installed.
ʑ
The mains cable may only be replaced by a qualified electrician (if required).
Replacement mains cables are available from customer services.
ʑ
Do not use multiple plugs/couplings or extension cables.
ʑ
If a residual current circuit breaker is used, only use a type which displays this
symbol:
‚
.
Only this symbol guarantees compliance with the currently applicable regulations.
ʑ
Mains plug:
– do not plug in to/pull out of the socket with damp hands.
– when removing the plug from the socket, pull the plug body only, not the cable.
– never pull the plug out during operation.
6
Transportation, e.g. when moving house
Before transporting the washing machine:
1.
Turn off the tap.
2.
Drain residual detergent solution
a
Instruction manual;
Maintenance - drain pump.
3.
Reduce the water pressure in the inlet hose
a
Instruction manual;
Maintenance - filter in
water inlet.
4.
Disconnect the washing machine from the power supply.
5.
Disconnect the hoses.
Install the transport safety devices:
1.
Remove the covers.
2.
Insert all 4 sleeves.
Clamp the mains cable to the holders. Insert and
tighten the screws.
After transportation, the transport safety devices must be removed.
a
Page 3.
To prevent unused detergent from flowing straight into the drain during the next wash:
Pour 1 litre of water into compartment II and start the
Empty
programme.
Technical specifications
ʑ
Dimensions (width x depth x height)
60 x 59 x 85 cm
ʑ
Weight
63 - 83 kg
depending on model
ʑ
Mains connection
Nominal voltage 220-240 V, 50 Hz
Nominal current 10 A
Nominal power 2,300 W
ʑ
Water pressure
100-1000 kPa (1-10 bar)
1.
2.
ʑ
a
ʑ
ʑ
ʑ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
