Installation
30
The appliance can work in the following
modes:
•
220-240 V 1N
~
Use a
3 x 0.75 mm²
three-core
cable.
Fixed connection
Fit the power line with an omnipolar circuit
breaker, with contact separation of at least
3 mm, in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Connection with plug and socket
Make sure that the plug and socket are of
the same type.
Avoid using adapters, gang sockets or
extensions as these could cause
overheating and a risk of burns.
Testing
At the end of installation, carry out a brief
inspection test. If the cooktop fails to
operate, after checking that you have
carried out the instructions correctly,
disconnect the appliance from the power
supply and contact Technical Support.
5.8 Instructions for the installer
• The plug must be accessible after
installation. Do not bend or trap the
electrical power cable.
• The appliance must be installed
according to the installation diagrams.
• Do not try to unscrew or force the
threaded elbow of the fitting. You may
damage this part of the appliance, which
may void the manufacturer’s warranty.
• Use soap and water to check for gas
leaks on all connections.
DO NOT
use
naked flames when looking for leaks.
• Turn on all the burners separately and at
then all together to make sure that the
gas valve, burner and ignition are
working properly.
• Turn the burner knobs to the minimum
position and check that the flame is
stable for each individual burner and all
the burners together.
• If the appliance does not work correctly
after having carried out all the checks,
contact your local Authorised Service
Centre.
• Once the appliance has been installed,
please explain to the user how to use it
correctly.
The values indicated above refer
to the cross-section of the internal
conductor.