User Manual
GW2145 - GW1160 - GW4060 - GW4190
Page 37 - 86
fig. 25 – RESET: during the RESET the display shows “ P- “. At the end of the RESET cycle, “ E- “ appears on the display.
4.13
PRINTING THE CYCLE AND APPLIANCE PARAMETERS
If the Smeg “WD-PRINTE” accessory has been installed,
it is possible to force printing of the data relating:
1.
To the last cycle performed: by pressing the
1 On/Off
and
2 Functions
keys simultaneously.
2.
To the setup parameters, by pressing the
3 Functions
and
4 LH Selection
keys simultaneously.
Print last cycle
+
Print parameters
+
Commands are only accepted if the door of the device is closed.
1
2 - 3
4
fig. 26 – Standard procedure for forcing printing.
Last cycle data: use “On/Off”+”Functions” keys; Parameters: use “Fun”LH Selection” keys.
5
SETUP MODE - “FUNCTIONS”
The appliance has setup procedures for modifying its operating parameters.
The setup mode can be accessed by pressing the “Functions” button and requires a password.
For reasons of security and responsibility, 4 levels of password are available to access different levels of functions and
settings::
1.
USER Level (1111)
2.
SUPERUSER Level (provided by the installation engineer)
3.
ENGINEER Level
4.
SMEG Level
