Cleaning and maintenance
32
Vapour Clean setting
1. Turn the function knob to the symbol
and
the temperature knob to the symbol
.
2. Set a cooking time of 18 minutes using
the programmer clock.
The Vapour Clean cycle starts a few
seconds after the last press on the
programmer clock keys.
3. At the end of the Vapour Clean cycle, the
timer will deactivate the oven heating
elements, the buzzer will start to sound
and the numbers on the programmer
clock dial will flash.
End of the Vapour Clean cycle
4. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
5. Use an anti-scratch sponge with brass
filaments on tougher encrustations.
6. In case of grease residues use specific
oven cleaning products.
7. Remove the water left inside the oven.
For improved hygiene and to avoid food
being affected by any unpleasant odours,
we recommend that the oven is dried using
a fan assisted function at 160°C for
approximately 10 minutes.
4.6 Extraordinary maintenance
Removing and installing the oven seal
To remove the oven seal:
• Unhook the clips in the 4 corners and in
the centre, then pull the oven seal.
To install the oven seal:
• Hook the clips in the 4 corners and in the
centre onto the oven seal.
Oven seal maintenance tips
The seal should be soft and elastic.
To keep the oven seal clean, use a non-
abrasive sponge and lukewarm water to
wash it.
We recommend wearing rubber
gloves for these operations.
For easier manual cleaning of the
parts difficult to reach, we
recommend removing the door.
