Instructions for the user
37
PROBLEM
POSSIBLE CAUSE
PROBABLE SOLUTION
Too much ice forming on back wall of
refrigerator section (layer of frost
more than 1 cm thick):
- Cooling temperature regulator
device set too high (meaning
lower temperature inside the
appliance);
- door opened often or for long
periods;
- Turn the regulator to a lower
setting (1-2) to increase the
temperature inside the appliance
slightly;
- check that the gaskets are
providing an airtight seal;
- open the door less often and for
shorter times;
- rise in atmospheric temperature
and humidity;
- do not place hot food or drinks
inside the refrigerator;
Too much ice forming in freezer
-
inside temperature setting
thermostat set on too low a
temperature;
- Turn the regulator to a lower
setting (1-2) to increase the
temperature inside the appliance
slightly;
- check that the gaskets are
providing an airtight seal: If they
are cracked, try to soften the
gasket by pulling it with one hand
and sliding your closed fingers
along the inside;
- open the door less often and for
shorter times;
- rise in atmospheric temperature
and humidity;
- do not place hot food or drinks
inside the freezer;
Front of cabinet hot to the touch
-
- the refrigerator is operating
normally. Inside the cabinet there
is a surface cooling system
designed to restrict the formation
of condensation in the area where
the door gasket closes.
Doors misaligned (except mod.
FAB28)
-
- check that the refrigerator is
levelled properly, also adjusting
the two rear feet if necessary
(except mod. FA311X/XS and
FAB310X/XS). Check whether
changing the settings of the four
feet improves the alignment.