Instructions for the User
48
14.4 what to do if...
The oven display is completely off:
• Check the mains power supply.
• Check whether an omnipolar switch upstream
from the oven feed line is in the “ON” position.
The oven does not heat up:
• Check whether the “showroom” mode has been
set, for further details see point “10.7 Secondary
menu”.
The controls do not respond:
• Check whether the “child lock-out function”
mode has been set, for further details see point
“10.7 Secondary menu”.
The cooking times are longer than those
indicated in the table:
• Check whether the “power limiter” mode has
been set, for further details see point “10.7
Secondary menu”.
After the automatic “pyrolysis” cleaning cycle
(only on some models) it is not possible to
select a function:
• Verify whether the interlock device has been
switched off. If it has not, the oven has a
protection device that does not allow functions
to be selected while the interlock device is
active.
The display shows ERR 4
(on pyrolytic models only):
• The interlock device has not hooked up to the
door properly. This might be because the door
was accidentally opened during its activation.
Switch off the oven and switch it on again
waiting a few minutes before selecting a new
cleaning cycle.
If the door is opened during a fan-assisted
function, the fan stops:
• This is not a fault. It is a normal operation of the
appliance, useful when cooking foods in order to
avoid excessive heat escaping. When the door
is closed, the oven will return to normal
operation.
If the problem has not been resolved or there are other types of faults, contact your local technical
assistance centre.
