Instructions for the user
15
11.
USE OF THE HOB
11.1
Lighting of the hob burners
Before lighting the hob burners check that the flame caps are in the correct position and that their
burner caps are in place, making sure that the holes
A
in the flame caps correspond to the spark
plugs and thermocouples.
The optional grid
B
is for use with “woks” (Chinese pans).
To prevent deterioration of the hob we have equipped the cooker with a raised pan stand
C
to be
placed underneath pans more than 26 cm in diameter.
The supplied reduction rest
C
is used also for small pans.
The drawing next to each knob shows the corresponding burner. The appliance
has an electronic lighting device. Simply press and turn the knob anticlockwise
to the minimum flame symbol , until the flame is lit. Hold the knob down for a
few seconds to allow the thermocouples to heat up. The burner may go out
when the knob is released: this is because the thermocouple has not been
sufficiently heated. Repeat the operation holding down the knob a little longer.
This operation is not necessary for burners without thermocouples.
11.2
Practical advice for using the hob burners
For better use of the burners and lower gas consumption, use covered vessel that are proportional in
size to the burner to prevent the flame from licking the sides (see paragraph “11.3 Diameter of the
vessels to be used on each burner”). When water reaches the boiling point, lower the flame so that it
doesn’t overflow. To avoid burns or damage to the hob, all vessels or griddle plates must be placed
within the perimeter of the hob. All vessels must have a flat and smooth bottom. When using fats or
oils, be extremely careful that they don’t overheat and catch fire.
If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before trying to
re-light the burner.
11.3
Diameter of the vessels to be used on each burner
BURNERS
Ø min. and max.
(in cm)
1
Auxiliary
12-14
2
Semi rapid
16-24
4
Triple crown
18-26
Содержание CC62MFX5
Страница 24: ...914772191 F...
