10
An operator’s finger may get caught between the optional adjuster and product.
Install a cover as a safety measure if an operator can get close to the slide table during operation.
8) Keep away objects which are affected by magnets.
Since the product has built-in magnets, do not allow magnetic
disks, magnetic cards or magnetic tapes to come close. Data
may be erased.
9) When mounting the product, tighten it with screws of
appropriate length at an appropriate torque less than the
maximum tightening torque.
Tightening to a torque greater than the specified range may cause
malfunction, and insufficient tightening may cause displacement
or dropping.
2-2 Precautions for mounting the adjuster on the left
！
！
！
！
Caution
Keep at least 3mm between adjusters mounted on the right
and left when they are side by side. If there is not sufficient
space between the adjusters, the auto switch may
malfunction.
2-3 Air supply
！
！
！
！
Warning
(1) Type of fluids
The operating fluid must be compressed air. Contact SMC if using the product with other fluids.
(2) Large amount of condensate
Do not use compressed air containing a lot of condensate, which can cause operating failure of the
pneumatic equipment. Install an air dryer or drain catch before the filter.
(3) Draining control
If an air filter is not drained, condensate will leak to the secondary side and cause operation failure of
the pneumatic equipment. When it is difficult to control drainage, the use of a filter with an auto
drain is recommended. For the details of compressed air mentioned above, refer to SMC catalog
"Compressed Air Purification System".
(4) Types of air
Do not use compressed air which contains chemicals, synthetic oils containing organic solvents, salts
or corrosive gases, etc., as this can cause damage or malfunction.
！
！
！
！
Caution
1) If ultra dry air is used as a fluid, it can reduce the lubrication characteristics of equipment
and affect the reliability (life) of equipment. Contact SMC beforehand.
2) Install an air filter.
Install an air filter close to the upstream side of the valve. A filtration degree of 5
µ
m or less should be
selected.
3) Install an aftercooler, air dryer or drain catch before the filter and take appropriate measures.
Do not use compressed air containing a lot of condensate, which can cause the operating failure of
the product and other pneumatic equipment.
4) Use the product within the specified fluid and ambient temperature range.
When operating at temperatures below 5
o
C, water in the circuit may freeze and cause breakage of
seals or malfunction. Corrective measures should be taken to prevent freezing.
For the details of compressed air mentioned above, refer to SMC catalog "Compressed Air
Purification System".
Keep at least 3mm.
