SMC Networks LECSB Series, Руководство по эксплуатации

Страница: 122 / 423

5 - 3
5. PARAMETERS
No. Symbol Name Initial value Unit
Control mode
Position Speed Torque
PA16 For manufacturer setting 0000h
PA17 0000h
PA18 0000h
PA19 *BLK Parameter write inhibit 000Bh
5.1.2 Parameter write inhibit
Parameter Initial
value
Unit
Setting
range
Control mode
No. Symbol Name Position Speed Torque
PA19 *BLK Parameter write inhibit 000Bh
Refer to
the text.
POINT
Turn off the power and then on again after setting the parameter to validate the
parameter value.
In the factory setting, this driver allows changes to the basic setting parameter, gain/filter parameter and
extension setting parameter settings. With the setting of parameter No.PA19, writing can be disabled to
prevent accidental changes.
The following table indicates the parameters which are enabled for reference and writing by the setting of
parameter No.PA19. Operation can be performed for the parameters marked .
Parameter No.PA19
setting
Setting operation
Basic setting
parameters
No.PA
Gain/Filter
parameters
No.PB
Extension setting
parameters
No.PC
I/O setting
parameters
No.PD
0000h
Reference
Writing
000Bh
(initial value)
Reference
Writing
000Ch
Reference
Writing
100Bh
Reference
Writing
Parameter No.
PA19 only
100Ch
Reference
Writing
Parameter No.
PA19 only