- 72 -
2. When reciprocating the actuator repeatedly with tiny strokes, operate it with full strokes at least
once a day or every 1,000 cycles. Otherwise, lubrication can be lost.
3. Do not use the product in applications where excessive external force or impact force is applied.
The product can be damaged. Each component that includes motor is made with accurate tolerances.
Even slightly deformed or misaligned of components may lead to product failure.
4. Return-to-origin does not work while in operation.
This function does not work during a positioning operation or a pushing operation.
5. Refer to a common auto switch (Best Pneumatics No 2), when an auto switch is built and used
within the system.
6. When conformity to UL is required, the electric actuator and driver should be used with a
UL1310 Class 2 power supply.
14.2 Mounting
Warning
1. Install and operate the product only after reading the Operation Manual carefully and
understanding its contents. Keep the manual in a safe place future reference.
2. Observe the tightening torque for screws.
Tighten the screws to the recommended torque for mounting the product.
3. Do not make any alterations to this product.
Alterations made to this product may lead to a loss of durability and damage to the product, which can
lead to human injury and damage to other equipment and machinery.
4. When using external guide, the guide axis should be parallel to the
electric actuator axis.
There will be damage/excessive wear on the lead screw if the external guide is not parallel.
5. When an external guide is used, connect the moving parts of the product and the load in such
a way that there is no interference at any point within the stroke.
Do not scratch or dent the sliding parts of the product tube or piston rod etc., by striking them with
other objects. Components are manufactured to precise tolerances, so the slightest deformation may
cause faulty operation.
6. Prevent the seizure of rotating parts.
Prevent the seizure of rotating parts (pins, etc.) by applying lubricating grease.
7. Do not use the product until you verify that the equipment can be operated properly.
After mounting or repair, connect the power supply to the product and perform appropriate functional
inspections to check it is mounted properly.
8. At the overhang mounted impeller fixation
There is a possibility that the power at the bending moment will damage the
electric actuator when
moving at high speed.
The metal support fittings which suppress the vibration of the main body of the
electric actuator are
installed.
Reduce the speed to the condition where the
electric actuator does not vibrate.
9. When mounting the
electric actuator or attaching to the
work piece, do not apply strong impact
or large moment.
If an external force above the allowable moment is applied, it may cause looseness in the guide unit,
an increase in sliding resistance or other problems.
10. Maintenance space.
Allow sufficient space for maintenance and inspection.
