- 5 -
2. Outlines of Product
2.1 Features
Features of the controller.
Actuator control
Servo control enables the positioning and the operation with a specified thrust of
the actuator.
Operation and settings are available with the controller.
Settings can be altered and operation can be fun from the controller. Adjustments of the
position, speed, acceleration and test runs are available without the teaching box, PC, and
PLC.
Operation with specified thrust
The holding force and pushing force of the actuator can be controlled in three steps.
Separated power supply input
Power supply input is separated into the motor power supply and control power supply.
Even if the power supply for the motor is turned off, the information of the encoder position is
not lost while the control power supply is on, and parallel I/O control is available.
Automatic sequence function of the returning to origin position
Returning to origin position is available through I/O signal combination.
Alarm detection
Abnormal conditions are self-detected. Alarms are displayed by LED on the controller and
abnormal conditions are output to the outside by the parallel I/O terminal.
14 points positioning / pushing is available
Through the combination of parallel I/O inputs, 14 points (position number 1 to 14(E)) of
positioning / pushing are available. The speed and acceleration of the positioning can be set
by the switch for each operating direction.
Data input method
Parameter settings, test runs, and alarm resets can be performed by the controller.
Caution
When the device is set up or failure occurs, please refer to the operation manual of the actuator as
well as this operation manual.
* Keep this operation manual accessible so it can be referred to when necessary.
S