- 8 -
(2) Basic parameter settings
Select the settings in each item described below and
register them to the controller by clicking [Setup].
A. [Card Motor Product Number]:
Select the product number of the applicable Card Motor.
B. [Method to Return to Origin Position]:
Select homing method and position.
C. [Card Motor Mounting Orientation]:
Select horizontal or vertical.
D. [Step Data Input Version]:
Select Cycle Time Entry Method (recommended).
(3) Setting of the operating conditions
–Selection of operation type–
E. Select the [Step Data Setup] page.
F. Select operation type in the “Operation” selection
section.
Positioning operation
When transferring the workpiece to a specific position.
Pushing operation
When applying force to a workpiece or measuring the
size of it.
G. Select movement mode.
Absolute The Card Motor table will move the set
distance in relation to the “Origin Position”.
Relative
The Card Motor table will move the set
distance in relation to the current table
position.
(4) Setting of the operating conditions
–Entering of the operating values–
<
In Positioning Operation mode
>
H. Target Position [mm]
Distance from the Origin Position (or current table
position) to the Target Position.
I. Positioning
Time
[s]
Time required to move to the Target Position.
J. Load Mass [g]
Select the approximate weight of jigs or workpieces
mounted on the Card Motor table.
<
In Pushing Operation mode
>
H. Target Position [mm]
I. Positioning
Time
[s]
+
K. Thrust Setting Value
J. Load Mass [g]
H
I
K
J
A
B
C
D
E
F G