- 55 -
(5) If there is a risk of fire or personal injury due to abnormal heat generation, sparking, smoke
generated by the product, etc., cut off the power supply from this product and the system
immediately.
6. 2 Handling Precautions
(1) Never touch the inside of the controller and its peripheral devices.
It may cause an electric shock, or it may damage the controller.
(2) Do not operate or set up this equipment with wet hands.
It may cause an electric shock, or it may damage the equipment.
(3) Do not use a product that is damaged or missing any components.
Electric shock, fire, and injury can result.
(4) Do not connect the controller to other devices than the Card Motor.
It may cause damage to the controller or to the other equipment.
(5) Be careful not to touch, get caught or hit by the work piece while the actuator is moving.
It may cause an injury.
(6) Do not connect the power supply or power up the product until it is confirmed that the work
piece can be moved safely within the area that can be reached by the work piece.
The movement of the work piece may cause an accident.
(7) Do not touch the product when it is energized and for some time after the power has been
disconnected, as it is very hot.
It may cause burns due to the high temperature.
(8) Before performing installation, wiring and maintenance check for accumulated voltage using
a tester at least 5 minutes after the power supply has been switched off.
Accumulated voltage can result in electric shock, fire, and injury.
(9) Static electricity may cause malfunction or damage to the controller. Do not touch the
controller while power is supplied to it.
Take sufficient safety measures to eliminate static electricity when it is necessary to touch the
controller for maintenance.
(1) When the Multi-counter is not used, attach the counter plug to the counter connector of the
controller.
If foreign matter such as metal fragments enters the counter connector, short-circuit may occur.
(2) Be sure to perform return to Origin position prior to start.
If the Origin position is not set, the product will not operate even if the step data is performed.
(3) The positioning time entered and set in the controller setting software is just a target value. It
cannot be guaranteed.
The operation may not have been completed even if the set positioning time has passed. In such a
case, the BUSY and INP digital output signals can be used to detect when the operation has been
completed.
Warning
Caution