10 Specification for Option V
10 - 1
10 Specification for Option V
This product mounts the timer operated auto drain in Item 2 Specifications. When performing the
installation and maintenance work for the product, the following points must be understood and
followed. Additionally, read Item 3 for replacement work.
10-1
Safety
instructions
When handling the product, take care to the following precautions.
10-2
Specifications
The timer is set to have ON time of 0.5sec and OFF time of 0.5min. at the time of shipment from the
factory. Do not change this timer setting. If it is changed, water could be discharged from the outlet
line of the dryer. Service parts number will change depending on the power supply voltage of the
dryer.
Warning
1. Do not remove the auto drain if air pressure remains of the product. When removing the
auto drain, stop the supply of air to the primary side of the product, exhaust the air from the
secondary side and ensure there is no residual pressure. If the air pressure is left at the
inside of the product, parts could suddenly pop out and cause accident when loosened.
2. Put gloves to prevent injury when removing the auto drain.
3. Operator could touch the drain waste from repalced auto drain. Follow the procedures
prepared by the customer to keep safety of operators. (Ex. Put protective goggles, apron
and/or gloves to protect body from toucing the drain waste for replacement worken
replacing the product.)
Warning
Only qualified person must perform wiring.
1. Provide the power suitable for the product specifications.
2. Be suer to ground the product for the safety. Do not ground to water pipe, gas tube or
lightening rod line.
3. Do not connect too many wires to the same outlet, which could results in heat generation
and fire.
4. Do not retrofit the wiring of the dryer and the power supply line.