-19-
No.D-
※
S-OMG0006-C
■
Setting
Setting using the Adjustment trimmer.
“How to mount” depends on the actuator type and tube I.D.. Please refer to the actuator catalogue.
The size of the work piece (correct, too small, too large, or no work piece) can be verified by setting the
detection range of OUT1 and OUT2 within the operation range using the adjustment trimmer. (See below)
: As for standard products, the operating range depends on the actuator and tube I.D.. It cannot be varied.
The recommended torque applied to the adjustment trimmer is 2 to 20 mNm. The maximum rotation is 260
degrees. Make the adjustment within the specification range.
The scale of the trimmer does not show the operation range. Please only use this as a guide for setting.
<<Cautions when designing>>
For setting, do not move the actuator by hand. Use air to start the actuator.
The Detection range may vary depending on the air supply pressure, variation of the ambient magnetic field,
or the presence of any magnetic material.
The Minimum detection distance is 0.5 mm. This product is not applicable when the size difference of the
work piece is less than 0.5 mm in the stroke direction.
This product is not suitable for work pieces with unstable shapes such as rubber parts.
