IP8001-TFL21GB
4
WORKFLOW OF IP8001 POSITIONER SETUP
The workflow of IP8001 smart positioner from set-up to initial adjustment is
shown below. Follow this flow when performing set-ups and adjustments of
the positioner. Please refer to the manual for details.
5
MOUNTING
!
Example of Mounting on Actuator
The IP8001 Smart Positioner offers interchangeability in mounting pitch with
the IP600, IP6000 and IP8000 Positioners. Therefore, it is possible to apply
a bracket for IP600, IP6000 and IP8000 for mounting.
*11
5
MOUNTING (CONTINUED)
*11: There is a possibility that the connection and the feedback lever
interfere when the IP600 type is exchanged for the IP8001 type.
Please machine the connection or interpose the spacer between the
positioner and the bracket at that time.
*12: Do not impact on the feedback shaft of the positioner when the
feedback lever connected with the valve stem or installed in the
positioner.
*13: The installation direction of spring need not be changed by the
difference of the direction of operation unlike the IP8000 type.
6
PIPING
Table 3
Attach using the screw
holes at the rear of the
positioner and the screw
holes at the front mount
of the diaphragm valve.
Fig. 5
Directly attach using the
screw holes at the side
of the positioner and the
screw holes at the yoke
side of the diaphragm
valve.
Fig. 3
Attach using the screw
holes at the side of the
positioner and the screw
holes at the front mount
of the diaphragm valve.
Fig. 4
13
*
Connection of Feedback Lever
12
*
Fig. 6
(1) Attach the positioner so that the valve stem and feedback lever form
a right angle when the input current is 50% (distribute evenly with
50% input current set as the reference).
(2) Attach the positioner so that the operation angle of feedback lever is
within the range of 10
°
to 30
°
.
Fig. 2
