English
NOTE:
Select the Administrator option when running the
Installation. This will install both the Setup Wizard and the
BiAdmin management program.
3. Within the Setup Wizard, select the Print Server you wish to
configure, click Next, and step through the Wizard.
If the desired Print Server is not listed:
• Check all cables to the Print Server.
• Check the Print Server's LEDs:
• The red LED should be OFF and the green LED should be ON or
flashing.
• If your model supports 10BASE-T and 100BASE-T, check the
10/100BASE-T link LED next to the LAN connection. If the
auto negotiation fails, the 10/100BASE-T Link LED will not
light when the device is powered up. If there are 2 LEDs,
neither will light.
• Check that your PC and the Print Server are on the same LAN
segment. If you don't have a Router or Gateway on your LAN,
you only have 1 segment.
• Check that your PC has either the TCP/IP or NetBEUI network
protocols installed. See "Checking your Network Protocols" in
the chapter "Client PC Configuration" for details.
• If you PC can't configure the Print Server correctly (in
Infrastructure mode), then try to connect to LAN and disable the
Wireless.
Alternatives to the Windows Wizard
If you do not have a Windows 32bit platform available, use one
of the following methods to configure the Print Server.
Web Browser
See chapter “Web Interface Setup” for details
FTP
Using this method, the configuration file is downloaded from
the Print Server, edited, and then sent back. No software needs
to be installed.
See the UNIX manual for details. The Unix manual is on the
CD-ROM, in the Manual\Unix folder.
11