SMAY WKP-O, Техническая документация инструкция

Страница: 16 / 28

Version 6.00
Date of editing: 16.09.2022 r.
Page 15 z 27
Technical documentation
WKP-O
The honeycomb mesh cover are made in the following series of types according to their width*
B
of the damper
B
of the mesh cover
B
of the damper
B
of the mesh cover
200-250 570 701-750 1070
251-300 620 751-800 1120
301-350 670 801-850 1170
351-400 720 851-900 1220
401-450 770 901-950 1270
451-500 820 951-1000 1320
501-550 870 1001-1050 1370
551-600 920 1051-1100 1420
601-650 970 1101-1150 1470
651-700 1020 1151-1200 1520
* In a special version, the honeycomb mesh cover can be made with dimensions different from the typical ones.
7. CONDITIONS OF TRANSPORT AND STORAGE
WKP-O should be stored in cardboard boxes and/or on pallets. WKP-O should have a pre-protected actuator cardboard
box. Fire dampers should be stored indoors, providing protection against atmospheric agents, at a minimum
temperature of +5°C.
Do not allow mechanical damage of damper, that may be caused e.g. blows or dropping.
During the transport the dampers should be package in cardboard, and/or put on a pallets and should be secured
before relocating, and against weather conditions. Be especially careful particularly with the WKP-O-E-T type dampers.
After each transport, visual inspection of each fire damper must be carried out.
8. INSTALLATION TECHNOLOGY
Before installing the fire dampers, make sure that there are no damage, during transport or storage, that could block
the baffle.
Check that the baffle can be opened and closed (full opening and closing position). To open fire dampers WKP-O use
the actuator key.
The opening and closing must proceed smoothly (not stepwise).
Do not pull by baffle to open or close fire damper, it may cause permanent damage, not covered by the warranty.
Before installation verify dimensions of the gap between bottom blade and inside part of the housing under the blade,
and between top blade and inside part of housing above blade. The dimension of the gap cannot be lower than 4 mm.
Before installing, secure the fire damper, by dust and dirt, using a foil or other screening material. It can prevent
components of fire damper by damage.
Dampers to preserve of the declared resistance, insulation and smoke leakage EIS120, EIS90, should be installed on
wall, which was classified as EIS120, EIS90.
It is allowed to install WKP-O dampers in wall with other fire-resistance, should be remembered that fire-resistance in
this situation is resistance of lowest classified (in this regard) element in this system.
Ducts made of flammable and non-flammable materials can be connected to the damper. Ducts should be installed
that they cannot load the damper during fire. Ducts lengthening during fire can be compensated by support and knee.
ATTENTION: Distance between fire dampers or fire damper and construction elements must be compatible with
standard 1366-2:
a. Minimal 200 mm between fire damper, which are installed in different ventilating wires,
b. Minimal 75 mm between fire damper and construction element (wall/ceiling).