SmartSight S1500e Series, Быстрое руководство по установке

Страница: 33 / 47

Quick Installation Guide Point-to-Point Connection
21
16
Configure the serial port parameters to match those of the
target equipment (for instance, camera or PTZ keyboard).
For more information, refer to the
SConfigurator User Manual .
The S1500e initial configuration is now complete.
Point-to-Point Connection
To view video on a monitor in a point-to-point context (as opposed
to using the nDVR
TM
software), you have to create a connection
between a transmitter and a receiver. Typically, both units sit on the
same IP subnet as SConfigurator and have the same VSIP port; to
access other units, refer to the unit discovery section in the
SConfigurator User Manual .
For more information about the connection process, refer to the
“Managing Connections” chapter, also in the SConfigurator User
Manual .
Note
The two units must have the same firmware version, with the following
exception: The S1504e and S1508e, both at firmware release 3.0, will work
with an S1500e receiver at version 2.60.