SmartSat OYSTER DIGITAL CI, Руководство по установке

Страница: 14 / 18

Page 14 of 18
10. Fitting of dish
When all interconnection and fitting is done you have to fit the
dish finally.
Attention: Before the first power up, check if all tools have been
removed from the TopBox. It might be a good idea to have an
assistant watching the TopBox when it is coming up first, if you
do not have direct sight to it when first powering up.
a) Switch on the main power switch on the receiver to "ON" (I).
b) Watch the sat-mouse. If you see a moving bar the antenna will
go up. If you just see a small dot, press the red button on the
remote to get it up. If you see two bars for more than 5 seconds
then something may be wrong with the power supply.
c) Watch the antenna while it is going up. As soon as the arm is
roughly vertical or slightly over vertical press EXIT on the
remote. The antenna has to stop movement immediately.
Be sure to beam the remote towards the sat-mouse while
pressing EXIT and to mount the batteries into the remote before
this operation.
When the arm is approximately vertical and stopped, you can fit
the dish onto the arm.