Smartrise DSD412, Руководство для стартапов

Страница: 14 / 22

Drive Startup Manual DSD412
Page 6 © 2020 Smartrise Engineering, Inc. All Rights Reserved March 5, 2020
Powering Up
Perform the following to power-up the drive.
Apply external power by closing the main disconnect.
Close the two-pole breaker and all pushbutton breakers.
Verify the LCD on the Smartrise board and the Magnetek Drive powers up.
Figure 5: Breakers
Setup
Perform the following connections as shown in the figures below. Attach a voltmeter across the
115 VAC source for the control power supply at A4TB3-1 & A4TB3-7.
Attach L1, L2, and L3 to the corresponding terminals on the drive.
Figure 6: Terminal Connections