SwitchLinc V2 Relay User’s Guide
HOW TO SET UP SWITCHLINC RELAY TO BE REMOTELY
CONTROLLED BY AN INSTEON CONTROLLER
Linking an INSTEON Controller to SwitchLinc Relay
To remotely control SwitchLinc Relay using another INSTEON Controller, follow these steps to link
SwitchLinc Relay and the INSTEON Controller together. Refer to your INSTEON Controller’s User’s
Guide for detailed instructions on how to properly install it and link it to SwitchLinc Relay. The following
will work for the most common INSTEON Controllers.
1. Select your INSTEON Controller from the list below and follow the method shown to put it into
Linking Mode
.
A.
A Second SwitchLinc V2 Relay
– Press and hold the Second SwitchLinc
Relay’s
Paddle Top
for 10 seconds, then release. To confirm that it is in
Linking Mode, the Second SwitchLinc Relay will flash the light that it is wired
to once and begin blinking the top LED in its LED Bar.
B.
ControLinc
™
V2 Tabletop Controller
– Choose the ON/OFF Button Pair you
want to use for controlling SwitchLinc Relay. Press and hold the
ON Button
of the pair for 10 seconds. To confirm that it is in Linking Mode, ControLinc
V2’s Status LED will begin blinking.
C.
KeypadLinc
™
V2
– Choose the ON Button you want to use for controlling
SwitchLinc Relay. Press and hold the
ON Button
for 10 seconds. To confirm
that it is in Linking Mode, KeypadLinc V2 will flash the light that it is wired to
once and begin blinking the ON Button that you pushed.
D.
Other INSTEON Controllers
– See the INSTEON Controller’s User’s Guide.
2. Press and hold the
Paddle Top
for 10 seconds on the SwitchLinc Relay that is
being controlled. To confirm linking, the SwitchLinc Relay will blink the top LED
in its LED Bar and flash the light that it is wired to. Depending on the INSTEON
Controller, you have about 4 minutes to perform this step before Linking Mode
times out automatically.
Page 16 of 32
