2444A2xx4 Rev. 8/16/2011 9:08 PM / See Owners Manual for Warranty Information, Patented
© Copyright 2011, Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Status LED
Charging
LED
Scene
Buttons
(Left Off,
Right On)
Set button
Micro-USB
Charging
Jack
Power
Switch
(Left Off,
Right On)
Quick-Start Guide
RemoteLinc
™
2 - INSTEON
®
Wireless Controller
Model: 2444A2
Introduction
Use the power of INSTEON to control your home with the convenience of
a compact and versatile wireless controller.
What's Included
•
RemoteLinc
2
Getting Started
It is recommended that you fully charge your RemoteLinc 2 prior to
programming. RemoteLinc 2 charges via a USB cable (Type A to Micro-B,
sold separately). The red charging LED will turn off once the battery has
been fully charged.
To turn on RemoteLinc 2, simply slide the power switch to the on position.
(see image).
Add RemoteLinc 2 (Button) to a Scene as a Controller
1) Tap on "^" on the RemoteLinc 2 scene button of choice
2) Adjust the responder to the "state" you want when the scene is activated from RemoteLinc 2
1
3) Press & hold RemoteLinc 2's Set button until the RemoteLinc 2 beeps
RemoteLinc 2’s LED will begin blinking
GREEN
4) Press & hold the responder’s Set button until the responder beeps (or until LED/Load flashes)
RemoteLinc 2 will double-beep and its LED will stop blinking
Responder’s LED will stop blinking (it may also double-beep)
5) Confirm that scene addition was successful by tapping on/off on your chosen RemoteLinc 2 button
The responder will toggle between the scene on level and off
1
If the responder is a multi-scene device, tap the Scene button you wish to control until it's LED is in the desired state (on or off)
Using RemoteLinc 2
RemoteLinc 2 contains four on/off button pairs. Each pair controls its own scene, sending commands to devices
linked specifically to the on/off button pair. Dimmable responders may behave differently, depending on whether
you tap, double-tap, or press & hold a button to activate/deactivate a scene. Non-dimming responders will only
turn full-on or full-off, no matter what method you use.
Tap
Double-tap
Press & hold
Ramp to on-Level or off
Full-bright or full-off
instantly
Brighten or dim until
released
The RemoteLinc 2 Status LED will flash
GREEN
once for each ON/BRIGHT command
sent and
RED
once for each OFF/DIM command sent
Warning: RemoteLinc 2 is permanently sealed. Do not attempt to open case. Doing so will damage the remote.
