Smartgen HRC200, Руководство пользователя

Страница: 9 / 16

HRC200 Industrial Remote Control User Manual Page 9 of 16
Table 6 Communication Channel Configuration Steps
Step Description
1 Turn the bottom screw cover anticlockwise to open the base.
2
Change the middle four jumper cap positions to configure the
communication channel and replace the battery at the same time.
3 Turn the bottom screw cover clockwise to close the base.
The receiver configures the communication channel via dial switch. It is 1 when the dial switch is
set to ON position, otherwise it is 0. The default dial switch position is 1111 (515MHz).
Table 7 Communication Channels
No. Channel Frequency (MHz)
1 0001 445
2 0010 450
3 0011 455
4 0100 460
5 0101 465
6 0110 470
7 0111 475
8 1000 480
9 1001 475
10 1010 485
11 1011 490
12 1100 495
13 1101 500
14 1110 505
15 1111 515
It is 1 when the dial switch is set to ON position, otherwise it is 0.
NOTE: When the dial switch is configured as 0000, it is configuration mode (refer to 4.1).
4.4 PAIRING
Table 8 Pairing Description
Method Process
Method 1:
Remote control waits
for receiver pairing.
1. Turn the remote control and receiver to the same channel. (see the
communication channel configuration, default channel is 515MHz.)
2. Turn on the remote control power, its power indicator keeps on. Long
press F2 key 6s, all indicators are flashing yellow, which means entering
pairing mode. Press F2 key again during LoRa pairing can cancel pair.
3.
Turn on the receiver power, POWER indicator keeps on. Insert a slender
needle less than 3.5mm in diameter into the PAIR hole vertically, then long
press PAIR key 6s.