Smartgen HAT600P Series, Руководство пользователя

Страница: 16 / 58

HAT600P Series ATS Controller User Manual Page 16 of 58
7.2
STATUS DESCRIPTION
Table 9 S1 Power Status
No. Status Name Description
1 S1 Normal Identify S1 normal identification delay
2 S1 Abnormal Identify S1 abnormal identification delay
3 S1 Voltage Normal Power value is within the specified range.
4 S1 Voltage None Voltage is 0.
5 S1 Voltage High Voltage is above the pre-set upper value.
6 S1 Voltage Low Voltage is below the pre-set lower value.
7 S1 Frequency High Frequency is above the pre-set upper value.
8 S1 Frequency Low Frequency is below the pre-set lower value.
9 S1 Loss of Phase Loss of one or two phase among A, B, C.
10 S1 Reverse Phase Sequence Wrong phase sequence A-B-C.
Table 10 S2 Power Status
No. Status Name Description
1 S2 Normal Identify S2 normal identification delay
2 S2 Abnormal Identify S2 abnormal identification delay
3 S2 Voltage Normal Power value is within the specified range.
4 S2 Voltage None Voltage is 0.
5 S2 Voltage High Voltage is above the pre-set upper value.
6 S2 Voltage Low Voltage is below the pre-set lower value.
7 S2 Frequency High Frequency is above the pre-set upper value.
8 S2 Frequency Low Frequency is below the pre-set lower value.
9 S2 Loss of Phase Loss of one or two phase among A, B, C.
10 S2 Reverse Phase Sequence Wrong phase sequence A-B-C.
Table 11 Genset Status
No. Status Name Description
1 Start Delay Delay time before genset start.
2 Stop Delay Delay time before genset stop.
3 Scheduled Not Start Display Scheduled Not Start lasting time when it is active.
4 Scheduled Start Display Scheduled Start lasting time when it is active.
5 S1 Cycle Start S1 Cycle Start finishing countdown when it is active.
6 S2 Cycle Start S2 Cycle Start finishing countdown when it is active.
7 S1 Genset Start Only active when system is "S1 Gen S2 Gen".
8 S2 Genset Start Only active when system is "S1 Gen S2 Gen".
9 Genset Start Genset start signal outputs.
10 Genset Standby None genset signal outputs.