Longo programmable controller LPC-2.ID2V
'OK' ID LED
[oOkLd]
:
While this command is active, OK LED1 is set.
Type: BOOL
Raw to engineering data:
“0” Fault LED1 off
→
“1” Fault LED1 on
→
'Room service' LED
[oRServ]
:
While this command is active, room service request LED4
is set.
Type: BOOL
Raw to engineering data:
“0” Room service LED4 off
→
“1” Room service LED4 on
→
'Do not disturb' LED
[oDNDist]
:
While this command is active, occupied message LED3
is set.
Type: BOOL
Raw to engineering data:
“0” Occupied LED3 off
→
“1” Occupied LED3 on
→
Feedback:
RFID ID received Word1
[iIDW1]
:
Upper (most significant) third of RFID code.
Type: WORD
Raw to engineering data:
0 .. 65535 0 .. 65535
→
RFID ID received Word2
[iIDW2]
:
Middle third of RFID code.
Type: WORD
Raw to engineering data:
0 .. 65535 0 .. 65535
→
RFID ID received Word3
[iIDW3]
:
Lower (least significant) third of RFID code
.
Type: WORD
Raw to engineering data:
0 .. 65535 0 .. 65535
→
New ID received
[iIDNew]
:
When new RFID tag is recognized, this status is set active for
10 seconds or till authorization command is received (
oOK
or
oFault
).
Type: BOOL
Raw to engineering data:
“0” Off
→
“1” New ID
→
Communication status
[iComm]
:
Normal state is “1”. If “0”, there is communication error
or no communication established.
Type: BOOL
Raw to engineering data:
“0” Error
→
“1” OK
→
'Room service' TB
[iRServ]
:
Active status denotes user has requested “room service”
message to be displayed.
Type: BOOL
Raw to engineering data:
“0” Off
→
“1” On
→
'Do not disturb' TB
[iDNDist]
:
Active status denotes user has requested “do not
disturb” message to be displayed.
Type: BOOL
Raw to engineering data:
“0” Off
→
“1” On
→
Occupancy switch
[iOccup]
:
When key-card is inserted, this parameter is active
Type: BOOL
Raw to engineering data:
“0” Key-card not inserted
→
“1” Key-card inserted
→
5