SMART PMCspan, Руководство пользователя

Страница: 23 / 64

PMCspan PMC Carrier Module Installation and Use (6806800A59C) 23
Chapter 2
Hardware Installation
2.1 Introduction
The following sections discuss the installation of the PMCspan modules and PMC modules.
The following installation procedures are provided:
 PMC module on a PMCspan
 PMCspanX6E-002 Primary PMC Carrier Module on a MVME5100 or MVME5500
VME processor module
 PMCspanX6E-010 Secondary PMC Carrier Module on a PMCspanX6E-002
Primary PMC Carrier Module
Refer to the installation instructions in VME processor module’s installation and use manual
before proceeding with these instructions.
2.2 Packaging
The PMCspan is packed in an anti-static package to protect it from any static discharge.
Observe standard handling practices of static sensitive equipment.
NOTE: Each PMCspan ships with a standoff hardware kit for attaching the primary
PMCspan to the VME processor module and the secondary PMCspan to the
primary PMCspan.
2.3 ESD Precautions
It is strongly recommended that you use an antistatic wrist strap and a conductive foam pad
when installing or upgrading a system. Electronic components, such as disk drives,
computer boards, and memory modules, can be extremely sensitive to electrostatic
discharge (ESD). After removing the component from its protective wrapper or from the
system, place the component flat on a grounded, static-free surface (and, in the case of a
board, component side up). Do not slide the component over any surface.
If an ESD station is not available, you can avoid damage resulting from ESD by
wearing an antistatic wrist strap (available at electronics stores) that is attached to
an active electrical ground. Note that a system chassis may not be grounded if it is
unplugged.