CHAPTER 5
MAINTAINING THE INTERACTIVE FLAT PANEL
29
l
Avoid touching the reflective tape between the screen and the frame, and ensure that this
strip stays dry. Damage to this strip affects touch interactivity.
To clean the screen
1. Turn off any connected computers.
2. Press the
Standby
button
on the front control panel twice.
3. Turn the interactive flat panel off by flicking the power switch beside the AC power inlet.
4. Wipe the screen with a lint-free, non-abrasive cloth.
Cleaning the camera windows and reflective tape
The interactive flat panel’s DViT technology uses four cameras in the corners of the frame and the
reflective material between the screen and the frame. Dust buildup on the camera windows or
reflective tape can impair touch performance.
Inspect these areas regularly for dust, and clean them if any obvious buildup has occurred.
CAUTION
l
Dust buildup on the camera windows and reflective tape will degrade touch performance.
SMART recommends that you inspect the camera windows and reflective tape for buildup
and clean weekly.
l
Do not use compressed air to clean the camera windows or borders.
l
Do not use water, chemicals or cleaning agents.
l
Applying too much pressure when cleaning the tape or cameras can damage the tape and
cause performance issues or errors.
To clean the camera windows and reflective tape
1. Using a clean lint-free cloth, gently wipe the camera windows in the top corners and the
reflective tape along the top of the interactive flat panel screen.
2. Gently wipe the reflective tape along the sides of the interactive flat panel screen.
3. Gently wipe the camera windows in the bottom corners and the reflective strip across the
bottom of the interactive flat panel screen.
Содержание BOARD 8055i-G5
