Chapter 4
Maintaining the display
smarttech.com/kb/171414
50
To transport the display
Moving the display to the installation site
20.
Updating system software
When an update to the system software or firmware is available, the display downloads the update in
the background then waits for four hours of inactivity. When that happens, the display shows a
two-minute countdown before the update begins. You can interrupt the countdown at any time. The
display shows a blank screen for several minutes. When the update is complete, the iQ home screen, or
input lobby appears.
Note
You can configure your organization’s network to allow or prevent automatic system software and
firmware updates (see Connecting to a network).
Applying an automatic system software update manually
If the display has downloaded the system software update but hasn’t yet applied the update, you can
start the update process manually from Settings.
To apply an automatic system software update manually
1. From the Home screen, tap
Settings
.
2. Scroll to
Software Update
.
3. Under
Check for Updates Now
, tap
Apply Update Now
.
The display turns off and then turns back on. The display then applies the update.
Updating system software manually
You can download system software updates at smarttech.com/downloads and update your display
using a USB drive.
Note
Instructions for downloading and installing system software updates are provided on the software
downloads page.
