Smart Technologies SMART Board 800i5e-SMP, Конфигурация и руководство пользователя

Страница: 104 / 118

Audio controls
These commands control your projector’s internal audio amplifier, which affects sound passed
through the projector to your external audio system (not included). Audio output controls aren’t defined
by the video source. These settings are unavailable when the projector is in Standby mode.
These commands inform you of the current audio output settings.
Command Response
get volume volume=[current volume setting]
get mute mute=[current mute setting]
get volumecontrol volumecontrol=[current volume control setting]
These commands control your projector’s audio amplifier settings. See Value-based command
methods on page 86 for setting absolute and adjustment commands.
Command Command target range Response
set volume [value] =-20 to =20 volume=[value]
set mute [target] =on
=off
mute=[target]
set volumecontrol [target] =on
=off
volumecontrol=[target]
Network controls
These commands control your projector’s network status and settings. These settings are located in
the OSD, and are available even when the projector is in Standby mode. You must locally set the
network and VGA out commands to on for the network abilities to work.
These commands inform you of the current network settings.
Command Response
get netstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp dhcp=[current DHCP status]
get ipaddr ipaddr=[current IP address]
get subnetmask subnetmask=[current subnet mask number]
get gateway gateway=[current network gateway]
get primarydns primarydns=[current primary domain server]
get macaddr macaddr=[current MAC address]
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
92