Smart Technologies SMART Board 4000i, Руководство по установке, Страница: 30 / 48

24 Basic Operations 99-00582-20 REV A0
LinQ software
With LinQ software, you can link a laptop to a SMART interactive product. After you establish a
connection, you can use LinQ software to show the laptop’s video output on the interactive screen.
To establish a communication link between the 4000i and a laptop, you must:
• install and open LinQ software on the laptop computer.
• be connected to the same network as the 4000i’s internal computer.
• start the mobile device manager software on the 4000i’s internal computer.
For more information about LinQ software and mobile device manager software, see
http://www2.smarttech.com/st/en-US/Support/Downloads/LinQ/.
Changing the Projector’s Display Source
You can use the three source buttons on the control panel to change the projector’s video and
audio input source. Choose from the internal computer, a connected guest laptop or an external
computer, a VCR or a DVD player.
NOTE: It takes a few seconds for the 4000i to switch from one input source to another. During that
time, all control panel buttons are disabled.
Press the VCR/DVD Player button on the control panel.
If both a VCR (composite video connection) and a DVD player (S-video connection) are connected
to the projector, pressing this button switches between the two. There is a three-second delay
before the alternate display source appears.
When you press the VCR/DVD Player button, you switch to the input source that was last active.
For example, if you view a DVD and then switch the display source to the internal computer,
pressing the
VCR/DVD Player button will switch the display source to the DVD player.
IMPORTANT
The 4000i is optimized for use with a high-resolution computer data signal.
To switch to a connected VCR or DVD player
VCR/DVD Player
Internal Computer
Guest Laptop