Smart Technologies SMART Board 2000i-DVS, Руководство по установке

Страница: 31 / 67

Finalizing the Installation 21
Finalizing the Installation
With your computer and projector on, finish setting up your 2000i by:
• adjusting the projected image (this page)
• configuring the computer settings (page 27)
• installing SMART Board software on any connected computer (page 29)
• configuring the computer port (page 29)
• orienting the interactive whiteboard (page 30)
After you’ve made these adjustments and configurations, your 2000i is ready to use.
Adjusting the Projected Image
You may need to adjust the projector to obtain a focused image that fits on the screen. Complete
the four adjustment procedures that follow only as required. For the first three, (adjusting image
roll, adjusting the image laterally, and adjusting the image size), you must watch the image on the
back of the screen while making adjustments. You’ll also need to remove the view port cover
(attached with hook-and-loop fastener strips) to access the adjustment hardware at the rear of the
unit.
For the final procedure (adjusting the image vertically), adjust the image while watching it from the
front of the unit.
CAUTION Do not adjust the ring that surrounds the short-throw, customized projector lenses,
even though the NEC VT470/570/670 User’s Manual states that you should use
this ring to obtain the best focus. You must disregard this information. If you move
the ring, you may cause the lenses to separate.
Rather, use the Zoom lever on the projector, which has been modified to adjust the
image focus. Again, contrary to the
NEC VT470/570/670 User’s Manual , the Zoom
lever will not adjust the image size on the screen.
View Port Cover