Smart Technologies SMART Board 2000i-DVS, Руководство по установке

Страница: 16 / 67

6 About the 2000i
3. Adjust the focus by moving the lever, and then tighten the slot-head screw you loosened in the
previous step.
Control Panel
Use the control panel to turn the projector lamp on and off, change the display source for the
projector, open Notebook software, and adjust the volume of the internal sound system.
During normal operation, you should keep the projector turned on all the time. However, to
conserve the lamp, put the projector into standby mode at the end of your session (or at the end of
the day). In standby mode, the projector lamp is turned off, but the projector itself remains on.
To put the projector into standby mode, press the Lamp Off button on the control panel. For the
next three minutes, the lamp is in a reversible standby mode. The screen appears black, even
though the projector lamp remains on, allowing you to quickly restore the display by pressing any
button on the control panel.
After three minutes, the lamp cools down for 60 seconds and is then turned off.
You can skip this three-minute reversible standby period by pressing and holding the Lamp Off
button for three seconds. To turn on the projector lamp, press the Lamp On button.
CAUTION
Do not over-tighten the screw.
The Lamp On and Lamp Off Buttons
Lamp On
Volume Up
Guest Laptop
On LED
Lamp Off
Volume Down
VCR/DVD
Player
Notebook
Software
Off LED
Internal Computer