User manual of iPR-x proximity readers
iPR-2 iPR3 iPR6 iPR-7 iPR-8 iPR-9
Function
iPR-x proximity readers is intended to be applied in different access control systems, using RS232, Wiegand
26, Wiegand 37 or Wiegand 42 interface. (Reader iPR-9 have with built-in keypad).
Types of identificators
Smart Innovations manufactures readers operating with amplitude modulation (ASK) proximity cards and
tags.
Design
The reader is placed in miniature hermetic plastic or vandal-proof of polished stainless steel (iPR-3) case.
Thanks to the small overall dimensions the reader is distinguished for its advanced reliability.
Specifications
Warm-up time
10 seconds after power start
Case
Material
ABS plastic (1.5 mm thick stainless steel iPR-3)
Dimensions
iPR-2 iPR-3 iPR-6 iPR-7 iPR-8
iPR-9
mm 150
х
45
х
22 110
х
80
х
15 95x50x16 95
х
50
х
16 105-200 105-200
Weight
iPR-2
iPR-3
iPR-6
iPR-7
iPR-8 iPR-9
gramm 50
150
105
105
94
94
Ambient Conditions
Temperature
-35 . . . +65
0
С
Humidity
100% (without condensate)
Power supply
Voltage
+9. . . +16 V of direct current
Current
up to 50 mA
Maximal current up to 80 mA
Voltage ripple up to 500 mV.
Distance of reading
Typical reading distance show in table 1 and depends on tag type used with it. This parameter is valid for
power supply voltage range from +9 to +16 VDC and ripple up to 150 mV
p-p
.
Table. 1
Reader
type
iPR-2 iPR-3
iPR-6 iPR-7 iPR-8 iPR-9
Distance,
mm 150-160 35-40 105-200 140-150 105-200 105-200
Wiring
Reader has 8-wire colored cable intended for connection to access control panel.
Table 2. The wires assignment:
Multiwire signal cable with 0.22 mm
2
wires' cross-sectional is recommended to use for connection of the
reader and control panel. Using this cable the maximum length of 50 meters can be obtained.
Type of interfaces
The proximity reader is intended to be applied in different access control systems, using RS232, Wiegand 26,
Wiegand 37, Wiegand 42 or TouchMemory interface.
Mounting
It is recommended to mount the reader on a wall closely to a door at
appropriate height.
!
Do not mount the reader on metal surface, since it causes decreasing of
reading distance.
!
If two readers are mounted at a distance less than 50sm, reading distance
of a card may be reduced appreciably. In such a case, connect yellow
wires of the readers. The readers will synchronize and work in turn.
!
Synchronization allows mounting of two readers at a small distance, to the
extent of reading distance of a card. In case that, two readers are mounted
at a distance less than reading distance of a card the card may be read by
the reader behind the wall.
To mount the iPR-2, iPR-3 readers proceeds as follows:
- Connect the reader to the control panel's cable
Table. 2
W2/W3/W4/WS
RS232
Color Function
Green Data
0
Rx
White Data
1
Tx
Red +V +V
Black GND GND
Brown Red
Led
–
Orange Green
Led
–
Blue Beep
–
Yellow Hold/Synch Hold/Synch
1
Smart Innovations