SMART Embedded Computing PCIE-7217, Инструкция по установке и эксплуатации

Страница: 48 / 108

48 PCIE-7217 Installation and Use (6806873A01B)
Hardware Preparation and Installation
Hardware Preparation and Installation
2.4.1 ESD Prevention
Static electricity may cause injury or damage the device. To minimize the damage, pay
attention to the following points:
 Before handling or touching the card or electronic components, make sure that you
are working in an ESD-safe environment.
 Before you install the device, wear the ESD-preventive wrist strap. Both terminals
of the ESD-preventive wrist strap must contact well. One terminal touches your
bare skin, and the other is inserted in the ESD bond point (jack) located on the back
of the shelf.
 Avoid moving as much as possible. Movement gathers static electricity around
you.
 Do not touch the solder point, pin, or bare circuit.
 Do not leave the device in the place where others can operate it.
 Install the device at once after you take it out of the antistatic package. If you need
to lay down the device, place it back in the antistatic package. Do not lay the device
on the shelf or cabinet.
 Monitor the temperature and humidity of the equipment room. Warm air decreases
the humidity but increases the static electricity in the room.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage
circuits or shorten their life. Before touching the module or electronic components,
make sure that you are working in an ESD-safe environment.
Shipping the card with a server is not recommended.
If you need to ship the card with the server, make sure the card is properly secured
in the server. Necessary precautions must be followed to keep the card stable to
avoid damage to the card. For more information about securing the PCIe card in a
server, refer to the product documentation listed in
Appendix A, Related
Documentation on page 105
.