C H A P T E R 3
Using your interactive whiteboard system
13
Setting
Use
Notes
V-Position
Moves the vertical position
of the source video up or
down from -5 to 5 (relative to
the projected image).
Don’t adjust this setting unless you’re advised
to by SMART Support.
Apply this setting only after you make all boom
adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
White Peaking
Adjusts the image colour
brightness from 0 to 10
whilst providing more vibrant
white shades.
A value closer to 0 creates a natural image and
a value closer to 10 enhances brightness. The
default is 10.
Degamma
Adjusts the colour
performance of the display
from 1 to 3.
The default is 2.
Colour
Adjusts the Red, Green,
Blue, Cyan, Magenta and
Yellow colours on the
projector from 0 to 100 to
provide custom colour and
luminance output.
Each colour has a default value of 100.
Adjustments to the colour settings register
under the User mode.
Audio menu
Volume
Adjusts the projector’s
volume amplification from -
20 to 20.
The default is 0.
Mute
Mutes the projector’s audio
output.
The default is off.
If you mute the projector’s audio output and
then increase or decrease the volume, the
volume is restored automatically. You can
prevent this from happening by disabling the
volume control.
Disable Volume
Control
Disables the projector’s
volume control.
Line out
Enables or disables the line
out.
The default is on
Microphone
Enables or disables the
microphone
The default is on
Speaker
Enables or disables the
speaker
The default is on
