SMART Board Board X800i4, Конфигурация и руководство пользователя

Страница: 82 / 104

Projector programming commands
This section documents the projector programming commands.
Projector powerstate controls
SMART UF65 or SMART UF65w projectors respond to commands only at certain power levels and
times.
There are five projector power states:
l
Powering (startup)
l
On (operating)
l
Cooling
l
Confirm off
l
Idle (Standby mode)
Command inventory
SMART UF65 or SMART UF65w projectors respond to the commands in the tables on the following
pages. To see a list of valid commands in the projector’s current power state, type ? and press
ENTER.
N
N O T E S
l
Send a command after the projector sends a command prompt.
l
Commands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
l
Check your entries carefully before entering your commands.
l
Press ENTER after typing each command.
l
After the projector executes a command, it generates a response.
l
To avoid buffer overrun, don’t send another command until you receive the next command
prompt.
A P P E N D I X A
Remotely managing your interactive whiteboard system
72