4. Put the old lamp in a secure container and handle it gently until you recycle or dispose of it.
I
I M P O R T A N T
Recycle or dispose of the lamp module according to your local waste authority.
5. Remove the replacement lamp module from its packaging.
C
C A U T I O N
Do not touch any part of the lamp module except the housing.
6. Place the replacement lamp module in the lamp slot, push the lamp all the way down, and then
tighten the lamp locking screws until they’re secure.
7. Replace the outer lamp cover.
N
N O T E
You might need to adjust the projected image after you perform the previous procedures. For
more information, see the included
SMART Board X880i4 and X885i4 Interactive
Whiteboard System Installation Guide
) and
8. Replace the projector on the boom and connect the cables. See
Resetting the lamp timer
After you replace the lamp, you need to access the projector service menu and reset the lamp hour
counter. To prevent accidental errors, only a system administrator should perform this procedure.
N
N O T E
Always reset the Lamp Hours after you exchange a lamp because lamp service reminders are
based on the current hours of use.
g
To reset the lamp timer
1. Using the remote control, press the following buttons quickly to access the service menu:
Down
,
Up
,
Up
,
Left
,
Up
.
C
C A U T I O N
Do not adjust any settings in the service menu other than those listed in this guide. Changing
other settings can damage or affect the operation of your projector and invalidates your
warranty.
C H A P T E R 5
Maintaining your interactive whiteboard system
45
Содержание Board X800i4
