SMART Board Board 600i6, Конфигурация и руководство пользователя, Страница: 80 / 117

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
67
Command\response definitions
Command Response Responds when powered off
set input [target] input=[current] no
get input input=[current] yes
get videoinputs
videoinputs=[current
videoinputs]
yes
set usb1source [target] usb1source=[current] yes
get usb1source usb1source=[current] yes
set usb2source [target] usb2source=[current] yes
get usb2source usb2source=[current] yes
Field definitions
Field Possible values Description
current input
l
VGA1
l
Composite
l
HDMI1
l
None
The input source to switch to. None is a non-
selectable input and is returned in response to
a get input command when the projector is
turned off.
target input
l
= VGA1
l
= Composite
l
= HDMI1
l
= None
l
= Next
Target input to set the input to. If the input is
next, the projector will move to the next item
from the possible values list and return a
response equivalent to if the user had
specified that input directly.
current videoinputs
l
VGA1,
Composite,
HDMI1
Returns a comma separated list of the
available inputs on the projector. The strings
returned in this command must match the
strings used for the input selection from OSD.
VGA1 and HDMI1 are local at projector. VGA2
and HDMI2 are at UCP. The maximum could
be 10 inputs in the current list. (max 14
reserved).
current usb1source
l
VGA1
l
HDMI1
l
Disabled
Current value that the USB1 switch will be
enabled for.