SMA CP-JP Series, Руководство по установке

Страница: 19 / 28

6 Mounting SMA Solar Technology AG
Installation Manual 19 SCCP-JP_NR-IA-en-11
Procedure:
• Slide the ventilation plate into the guide rails in the inverter cabinet. The ventilation grid in the ventilation plate
should be facing the rear panel.
☑ The ventilation plate is flush with the inverter.
✖ The ventilation plate will not go all the way in?
• Grip the ventilation plate from underneath and press the middle part upwards while sliding it in.
6.8 Mounting the Kick Plate
A kick plate with an additional noise reduction must be mounted on the front side of the inverter.
Procedure:
1. Position and align the kick plate with soundproofing material on the enclosure.
2. Screw the previously retained pan head flange screws into the threads.
3. Tighten the pan head flange screws with a suitable screw driver (TX 30, torque: 8 Nm).
6.9 Mounting the Silencing Baffle
With the order option "Noise reduction", a silencing baffle is delivered with the inverter. The silencing baffle must be
mounted on the rear panel of the inverter cabinet. When mounting, use the allround paste from the scope of delivery
for the bolted connections.
Mounting the rear panel of the silencing baffle
Required mounting material:
☐ 2 cylindrical screws
☐ 2 contact washers
Procedure:
1. Remove all screws from the threads for attaching the silencing baffle.
2. Position the rear panel of the silencing baffle on the rear panel of
the inverter.
3. Screw two cylindrical screws with contact washers into the middle
threads on the rear panel (torque: 8 Nm).