1/2
BTPB_E-IUS092910
This document gives additional information on the installation of the SMA
Bluetooth
®
Piggy-Back.
This instruction does NOT replace the
Bluetooth
Piggy-Back Installation Guide. Pay attention to all
operation and safety instructions listed in the Installation Guide of the
Bluetooth
Piggy-Back. The
Installation Guide describes how to connect the
Bluetooth
Piggy-Back. The Installation Guide is
delivered with the
Bluetooth
Piggy-Back.
Determine a free NetID before installation of the SMA
Bluetooth
Piggy-Back
SMA Solar Technology recommends the determination of a free NetID using a mobile
communications device (e.g. Sunny Beam with Bluetooth or a laptop with Bluetooth and the Sunny
Explorer software) before installation of the communication interface. To find out how to determine a
free NetID please refer to the relevant instructions of the communications product.
Information for the installation of
the communication interface
Take note of the following additions to the installation of the
communication interface:
• During installation of the communication interface,
ensure that the communication interface is left-aligned
on the interface socket. The far right pins on the lower
short row of pins remain free.
Commissioning of a
Bluetooth
PV system always with 1 master only.
Always carry out the commissioning of a
Bluetooth
PV system with only 1 master (e.g.
Sunny Beam with
Bluetooth
, Sunny Explorer). You may integrate further masters into the
Bluetooth
Network as soon as the
Bluetooth
network exists.
Sunny Beam with
Bluetooth
and SMA
Bluetooth
Repeater
The Sunny Beam with Bluetooth and the SMA Bluetooth Repeater can not register any
Bluetooth devices which are set to NetID 1. Only NetIDs from 2 to 9 and from A to F are
possible.
SMA
BLUETOOTH
®
PIGGY-BACK
Version:
1.0
Mat.-Nr.:
98-0019110
